
14 - 20 WiNG CLI Reference Guide
Parameters
Example
rfs7000-37FABE(config-fw-policy-default)# storm-control unicast level 2 ge 2
rfs7000-37FABE(config-fw-policy-default)#
rfs7000-37FABE(config-fw-policy-default)#storm-control bcast log notifications
rfs7000-37FABE(config-fw-policy-default)#
[arp|bcast|mcast|ucast]{log}
[<0-7>|alert|critical
|debugging|
emergencies|errors|
informational|
none|notifications
|warnings]
• arp – The traffic type is ARP
• bcast – The traffic type is broadcast
• mcast – The traffic type is multicast
• ucast – The traffic type is unicast
For all the above, the following level and log options can be set
• level <1-1000000> [ge <1-8>|port-channel <1-8>|
up1|wlan <WLAN>] – Performs packet rate limiting
• <1-1000000> – Specify the allowed rate in packets/sec from <1-
1000000>
• ge <1-8> – Select a physical port to apply from 1-8
• port-channel <1-8> – Select a port-channel from
1-8
• up1 – Applies on the Uplink interface
• wlan <WLAN> – Select a WLAN to apply. The existing WLAN
must be specified
• log – Enables logging
• <0-8> – Select one numerical log level. All messages with and
below this severity are logged
• emergencies – System is unusable (level 0)
• alerts – Immediate action needed (level 1)
• critical – Critical conditions (level 2
• errors – Error conditions (level 3)
• warnings – Warning conditions (level 4)
• notifications – Normal but significant conditions exist
(level 5)
• informational – Informational messages (level 6
• debugging – Debugging messages (level 7)
Kommentare zu diesen Handbüchern