
5 - 26 WiNG CLI Reference Guide
• <WLAN> {on <DEVICE-OR-DOMAIN-NAME>} – Specify a
WLAN name
• {on <DEVICE-OR-DOMAIN-NAME>} – On AP/Controller or RF
Domain
• <DEVICE-OR-DOMAIN-NAME> – AP/Controller/RF Domain
name
wireless [client|dump-core-
snapshot|qos|wips]
Configures wireless service commands
• client beacon-request <MAC> mode [active|passive|table] ssid
[<WORD>|any] channel-report[<WORD>|none] {on <DEVICE-NAME>} –
Configures wireless client service commands
• beacon-request <MAC> – Sends an 802.11k Beacon Measurement
Request to a specified client
• <MAC> mode – Enter the MAC address of the client
• mode [active|passive|table] – Specify the mode in which the cli-
ent must make the measurement
• active – Requests the client to make the measurement in active
mode
• passive – Requests the client to make the measurement in pas-
sive mode
• table – Requests the client to make the measurement in table
mode
The following are common for the active, passive, and table sub-
commands
• ssid[<WORD>|any] – Specify an SSID for which the measurements must
be made
• [<WORD>|any] channel-report – Specify a particular SSID or any
SSID
• channel-report[<WORD>|none] – Configures channel report in the
request
• <WORD> {on <DEVICE-NAME>} – Specify a comma separated
list of channels
• none {on <DEVICE-NAME>} – Applies to all channels
• on <DEVICE-NAME> – On AP/Controller
• <DEVICE-NAME> – Specifies the AP/Controller name
• dump-core-snapshot – Triggers a debug core-dump of the wireless
module
• qos – Wireless QoS related serviceability commands
• delete-tspec <AA-BB-CC-DD-EE-FF> – Sends a DELETE-TSPEC
message to a specified client
Kommentare zu diesen Handbüchern