
13 - 6 WiNG CLI Reference Guide
13.1.3.1 address
dhcp-pool-mode
Specifies a range of addresses for the DHCP network pool
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
address [address {class} <DHCP-CLASS>|range <Low IP> <High IP>{class}
<DHCP-CLASS>]
Parameters
Usage Guidelines
Use the no address range command to remove the DHCP address range.
Use the address command to specify a range of addresses for the DHCP network pool. The DHCP server
assigns IP address to DHCP clients from the address range. A high IP address is the upper limit for providing
the IP address, and a low IP address is the lower limit for providing the IP address.
Example
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1)#address range 1.2.3.4
5.6.7.8 class dhcp1
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1)#
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1)#address 1.2.3.4 class
dhcp1
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1)#
[address {class} <DHCP-
CLASS>|range <Low IP> <High
IP>{class} <DHCP-CLASS>]
• address – Specify the address to include in the network pool
• range – Adds an address range for the DHCP server
• <Low IP> – Defines the first IP address in the address range
• <High IP> – Defines the last IP address in the address range
The following parameters are common for both the address and range
• class – Specify the DHCP class name to which the address range
is attached
• <DHCP-CLASS> – Specify the name of the DHCP class
Kommentare zu diesen Handbüchern