Motorola TETRA MTM800 Installationshandbuch PDF herunterladen (Seite 32)

32 MTM700/MTM800 Mobile Terminal / Installation Manual INSTALLATION

DC Power Cable Installation

Installation Planning

The 3 meters (10 feet) DC power cable shipped with the terminal should be long enough to be

installed in most vehicles. Take the following precautions before you begin:

1. Whenever possible, avoid routing the cable above the catalytic converter.

2. Make sure that the power cable never rests on sharp edges.

3. Use grommets whenever a cable has to pass through a hole in a metal panel.

The following table lists power cables available for this terminal:

* For more information refer to section “Ignition Sense Cable”. The Ignition Sense Cable allows the

terminal to be turned on and off by the vehicle ignition switch.

CAUTION: This terminal must be operated only in negative ground electrical

systems. Operating the terminal on a positive ground system will cause the cable

fuse to short-circuit. Check the vehicle ground polarity before you begin the

installation.

Table 1 DC Power Cables

Number Description Rating

GKN6270 Power Cable to battery with fuse 10A 12V Power Cable to Battery, Length: 3 m

GKN6274 Power Cable to battery with fuse 10A 12V Power Cable to Battery, Length: 6 m

HKN9327 * Ignition Sense Cable with fuse 4A Ignition Sense Cable, Length: 3 m

6500139767 Fuse 10A for Power Cable

6580283E02 * Fuse 4A for Ignition Sense Cable

In case of blown fuses ONLY replace those with identical value.

NEVER insert different values.

C a u t i o n

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 81 82

Keine Kommentare

Motorola TETRA MTM800 Installationshandbuch Seite 32