Motorola TETRA MTM800 Installationshandbuch PDF herunterladen (Seite 6)

viii MTM700 Mobile Terminal / Installation Manual Product Safety and RF Exposure

• Use only Motorola-approved supplied antenna or a Motorola approved replacement

antenna. Unauthorised antennas, modifications, or attachments could damage the terminal and

may result in non-compliance with RF Safety Standards.

Approved Accessories

• This terminal has been tested and meets the RF Safety Standards when used with the Motorola

accessories supplied or designated for this product. Use of other accessories may result in non-

compliance with RF Safety Standards.

• For a list of Motorola approved antennas, please see your dealer or local Motorola contact. Your

nearest dealer can be found at the following web site:

http://www.motorola.com/businessandgovernment/wemea/en-gb/public/functions/dealerlocator/

dealerlocator.aspx

Additional Information

• For additional information on exposure requirements or other training information, visit

http://www.motorola.com/rfhealth

Compliance and Control Guidelines and Operating Instructions for Mobile

Two-Way Terminals Installed as Fixed Site Control Stations

If mobile terminal equipment is installed at a fixed location and operated as a control station or as a

fixed unit, the antenna installation must comply with the following requirements in order to ensure

optimal performance and compliance with the RF energy exposure limits in the standards and

guidelines listed on previous page:

• The antenna should be mounted outside the building on the roof or a tower if at all possible.

• As with all fixed site antenna installations, it is the responsibility of the licensee to manage the

site in accordance with applicable regulatory requirements and may require additional

compliance actions such as site survey measurements, signage, and site access restrictions in

order to insure that exposure limits are not exceeded.

Electromagnetic Interference/Compatibility

Note: Nearly every electronic device is susceptible to electromagnetic interference (EMI) if inade-

quately shielded, designed or otherwise configured for electromagnetic compatibility. It may be nec-

essary to conduct compatibility testing to determine if any electronic equipment used in or around

vehicles or near fixed site antenna is sensitive to external RF energy or if any procedures need to be

followed to eliminate or mitigate the potential for interaction between the terminal transmitter and the

equipment or device.

1 2 3 4 5 6 7 8 9 10 11 ... 81 82

Keine Kommentare

Motorola TETRA MTM800 Installationshandbuch Seite 6