Motorola TETRA MTM800 Installationshandbuch PDF herunterladen (Seite 46)

46 MTM700/MTM800 Mobile Terminal / Installation Manual INSTALLATION

5. Connect the flex from the Standard Control Head to Remote Back Housing PCB.

Figure 13 Orientation of Flex to PCB

6. Press the Standard Control Head onto the Remote Back Housing until ALL the tabs snap into

place.

Assembling the Remote Front Housing to Transceiver Box

1. Connect the flex from the Remote Front Housing PCB to the top small connector of the

Transceiver Box.

2. Press the Remote Front Housing to the Transceiver Box until ALL the tabs snap into place.

Installing the Remote Standard Control Head

1. Position the trunnion in the desired location and mark the positions of the mounting holes

using the trunnion mounting bracket as a template. Be careful that the housing is not affected.

2. Centrepunch the marked spots and drill 4mm (5/32-inch) holes at each spot.

3. Fix the trunnion in position using the supplied screws.

4. Route the Remote Cable as required, feeding it through the bracket (a 20mm hole is required

for the cable plug).

5. Push the cable plug into the Remote Front and Back Housing until it snaps into place.

6. Snap the assembly into the trunnion.

7. Adjust the assembly as required then fix it in position with the wing screws supplied.

NOTE

For correct orientation of the flex align the “dot” on the flex with the ‘O’ on the PCB.

NOTE

For correct orientation of the flex align the ‘dot’ on the flex with the ‘O’ on the PCB.

Also align the“dot“ on the flex with the“O“ on the chassis of the Transceiver Box.

Marking on PCB

Marking on Flex

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 81 82

Keine Kommentare

Motorola TETRA MTM800 Installationshandbuch Seite 46