Motorola LM2000 Installationsanleitung PDF herunterladen (Seite 48)

48 DC 900-1331F

Freeway 2000/4000 Hardware Installation Guide

You can change the default FTP user name and FTP password that Freeway uses

by changing the corresponding boot parameters on the Freeway system. If you do,

remember that you must also change the user name and password of the FTP

account on the boot server.

4. The system administrator has assigned the following device names and addresses

in the UNIX

/etc/hosts ﬁle, the Windows NT hosts or lmhosts ﬁle, or using

your VMS TCP/IP package:

• Freeway server name and Internet address

• Boot server name and Internet address

• Gateway Internet address (if applicable)

The procedure for conﬁguring the Freeway system boot parameters is the same for

UNIX, VMS, and Windows NT systems. Freeway obtains the boot parameters from

local non-volatile memory during system boot. Therefore, when you conﬁgure the boot

parameters in the following steps, all applicable parameters must be conﬁgured.

Step 1:

Turn on the power. The power switch is located in the lower left corner of the back

panel. To turn on the power, press the rocker switch in the direction of the “|” symbol.

If your Freeway has an MVME 162 CPU board, the ﬁrst LED (far left) on the front panel

should turn from red to green. (See Figure 3–3 on page 56.) This indicates that internal

diagnostics have completed successfully. If the ﬁrst LED does not turn green, check the

installation steps to be sure you have performed each step correctly. If this does not

solve the problem, contact your Simpact customer service representative at 1-800-275-

3889. Note that only the ﬁrst LED is signiﬁcant at this point. Depending on what soft-

ware may have been preloaded by Simpact, one or more of the other LEDs may also

turn green. This is OK. The other LEDs are used as diagnostic indicators and are

explained in Step 7 on page 54.

The LEDs are not used for a Freeway with an MVME 2600 CPU board.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 85 86

Keine Kommentare

Motorola LM2000 Installationsanleitung Seite 48