Motorola LM2000 Installationsanleitung PDF herunterladen (Seite 43)

2: Hardware Installation

DC 900-1331F 43

Step 9:

Make sure that the power switch on the back panel is in the off (“0”) position, then con-

nect the ICP boards and WAN connector panels to your wide-area network as described

in Chapter 4.

Caution

We recommend that you power off the Freeway server and modem

during cable installation and removal. This will prevent damage to

an ICP due to electrical discharge as contact is made or broken.

Step 10:

Connect a VT100-compatible terminal or terminal emulator to Freeway.

If you have a Freeway with an MVME 162 CPU, use a standard EIA-232, 25-pin

straight-through (non-nulling) cable. Connect the male end of the cable to the female

connector labeled “terminal connector” on the back panel (see Figure 2–4 on page 38).

Connect the female end of the cable to the VT100-compatible terminal or emulator that

you want to use as a console.

If you have a Freeway with an MVME 2600 CPU, use an EIA-232, 9-pin-to-25-pin null-

modem cable. Connect the 9-pin female end of the cable to the male connector labeled

COM 1 on the front panel (see Figure 2–3 on page 36). Connect the 25-pin female end of

the cable to the VT100-compatible terminal or emulator that you want to use as a con-

sole.

You will use this terminal or emulator as a console to conﬁgure the boot parameters and

perform the initial system boot as described in Chapter 3. Later you can disconnect the

terminal or emulator because you can then perform these conﬁguration functions

using telnet or rlogin through any terminal or workstation connected to the network.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 85 86

Keine Kommentare

Motorola LM2000 Installationsanleitung Seite 43