Motorola LM2000 Installationsanleitung PDF herunterladen (Seite 31)

DC 900-1331F 31

Chapter

Hardware Installation

This chapter describes how to set up the Freeway communications server and connect

it to the network.

Step 1:

Review the safety guidelines in the “Safety Precautions” section on page 15.

Step 2:

Place your Freeway in the selected location. It can be installed in any standard 19-inch

rack. It can also be set on a table top where it will occupy about three square feet. There

should be room to set a monitor nearby and enough clearance to ensure that the air

vents will not be blocked.

The Freeway must be near a three-wire electrical outlet that supplies single-phase

power. At U.S. sites, 115V AC is required. Outside the U.S., check the Freeway’s voltage

rating. Step 7 on page 39 describes how to change the voltage rating if necessary. It must

also be near the LAN and WAN connectors that will be plugged into it.

Be sure the location meets the following environmental standards:

• Operating temperature: 32° – 122° F (0° – 50° C)

• Humidity between 5% and 80% (relative non-condensing)

• Altitude between 0 and 10,000 feet (0–3048 meters)

• Good ventilation

• Little or no dust

Temp is from

data sheet.

Humidity is

from Eric; he

didn’t like

what data

sheet said.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 85 86

Keine Kommentare

Motorola LM2000 Installationsanleitung Seite 31