Motorola USB08 Betriebsanleitung PDF herunterladen (Seite 87)

Address(es) overlap FLASH Command arguments, or the loading

addresses in an S19 file, overlap FLASH.

Some commands cannot write to FLASH

Address(es) overlap EEPROM Command arguments, or the loading

addresses in an S19 file, overlap EEPROM

(where available)

Address(es) overlap reserved memory

Address(es) overlap locked FLASH Command arguments, or the loading

addresses in an S19 file, overlap FLASH

memory when this has not been unlocked

Address(es) protected by FLBPR You are trying to write to FLASH locations

which are protected by the current value of the

Flash Block Protect register

Cannot page-erase vector area Some HC908 chips can only erase the vectors

by doing a mass erase

Address span not allowed Some commands can only write one type of

memory at a time

Integer argument expected

Must follow FIND or NEXT The NEXT command must immediately follow

a use of the FIND or NEXT command

Previous FIND failed NEXT cannot be used if a previous FIND or

NEXT was unsuccessful

Display and Change command was not found.

Argument out of range

Remote reset not available The Remote Reset function has not been set

Formatting error in S19 file For example: invalid checksum

Argument(s) not recognized

Too few arguments

Too many arguments

Address range error Usually because EndAddress is less than

StartAddress

String too short/long

Command not available in macros

Command only available in macros

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 99 100

Keine Kommentare

Motorola USB08 Betriebsanleitung Seite 87