Motorola LS3578 Bedienungsanleitung Seite 40
- Seite / 378
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
3 - 4 Symbol LS3578 Product Reference Guide
Scanner emits short low-short
high- short low-short high beep
sequence while it is being
programmed.
Out of ADF parameter
storage space.
Erase all rules and re-program with shorter rules.
Out of Synapse parameter
storage space.
Scan
Set Synapse Defaults
code, from the
appropriate Synapse Interface Guide, for cables
no longer in use and re-program the scanner for
the current host interface.
Scanner emits one short high
beep when it is not in use.
In RS-232 mode, a <BEL>
character is received and
Beep on <BEL> option is
enabled.
Normal when Beep on <BEL> is enabled and the
scanner is in RS-232 mode.
Cradle does not work after
following installation
procedures.
Cradle is not receiving
power.
Check system power.
Cable connections are not
secure.
Reinsert cables properly.
The scanner is not inserted
properly in the cradle.
Reinsert scanner.
Cradle is not properly
connected to the host.
Check that host settings are correct, and connect
the cradle to the appropriate port on the host.
Battery does not charge. Cradle is outside the
charging temperature range.
Charge within the recommended temperature of
32° to 104° F (0° to 40° C) nominal, 41° to 95° F
(5° to 35° C) ideal.
Table 3-1
Troubleshooting (Continued)
Problem Possible Causes Possible Solutions
NOTE If problems still occur, contact the distributor or Motorola Enterprise Mobility Support. See page xv for
contact information.
- Symbol LS3578 1
- Product Reference Guide 3
- Warranty 4
- Revision History 5
- Table of Contents 7
- Table of Contents vii 9
- Table of Contents ix 11
- Table of Contents xi 13
- About This Guide 15
- Notational Conventions 16
- Related Documents 17
- Service Information 17
- Chapter 1 Getting Started 19
- Unpacking the Scanner 20
- The Cradle 20
- Cradle Parts 21
- Connecting the Cradle 22
- Getting Started 1 - 5 23
- Supplying Power to the Cradle 24
- Mounting the Cradle 24
- Inserting the Battery 25
- Removing the Battery 26
- Scanner Charging LED 26
- Getting Started 1 - 9 27
- Configuring the Scanner 28
- Radio Communications 28
- Chapter 2 Scanning 29
- Parameter Menu Scanning 30
- Table 2-1 30
- Scanning 2 - 3 31
- LED Definitions 32
- Scanning 33
- Optimum Scan Angles 34
- Decode Zone 35
- Symbol LS3578-ER Decode Zone 36
- Specifications 37
- Troubleshooting 38
- Table 3-1 39
- Set Synapse Defaults 40
- Technical Specifications 41
- Table 3-2 42
- Table 3-3 42
- Scanner Signal Descriptions 43
- Figure 3-1 44
- Table 3-5 44
- Pin 4 Pin 3 Pin 2 44
- Table 4-1 46
- Wireless Beeper Definitions 47
- Radio Communications 4 - 5 49
- Bluetooth 50
- Technology Profile Support 50
- *General Discoverable Mode 51
- HID Host Parameters 52
- Radio Communications 4 - 9 53
- Swedish Windows 54
- UK English Windows 54
- Japanese Windows 54
- Portuguese/Brazilian Windows 54
- *Disable Keypad Emulation 56
- *Disable Function Key Mapping 57
- *Disable Simulated Caps Lock 58
- *No Case Conversion 58
- Auto-reconnect Feature 59
- Reconnect Attempt Interval 60
- Radio Communications 4 - 17 61
- Out of Range Indicator 63
- Scanner(s) To Cradle Support 64
- Radio Communications 4 - 21 65
- *Unlocked Pairing Mode 66
- Radio Communications 4 - 23 67
- Pairing Bar Code Format 68
- Radio Communications 4 - 25 69
- Set Interval to 4 Hours 70
- Set Interval to 8 Hours 70
- Set Interval to 24 Hours 70
- Set Interval to Forever 70
- Bluetooth Security 71
- PIN Code 72
- Encryption 73
- Chapter 5 User Preferences 75
- Scanning Sequence Examples 76
- Errors While Scanning 76
- User Preferences 5 - 3 77
- User Preferences 78
- Beeper Tone 79
- *High Volume 80
- *Beep After Good Decode 81
- Trigger Mode 82
- Aim Duration 83
- Beep on Insertion 83
- Transmit Code ID Character 85
- Scan Angle 85
- Prefix/Suffix Values 86
- Scan Data Transmission Format 87
- <PREFIX> <DATA> 88
- Data Format Cancel 88
- *Disable No Read 89
- Synapse Interface 90
- Batch Mode 91
- Batch Mode (continued) 92
- Report Scanner Version 93
- Report Scan Engine Version 93
- Report MIMIC Version 93
- Report Synapse Cable 93
- Table 6-1 97
- Keyboard Wedge Host Types 98
- *North American 99
- Ignore Unknown Characters 101
- Keystroke Delay 101
- Intra-Keystroke Delay 102
- Caps Lock On 103
- Caps Lock Override 103
- *Do Not Convert Wedge Data 104
- FN1 Substitution 105
- Send Make and Break 105
- Keyboard Maps 106
- NCR 7052 58-KEY 107
- ASCII Character Set 108
- Table 6-2 109
- Table 6-3 113
- Table 6-4 114
- Table 6-5 115
- Table 6-6 116
- Table 6-7 117
- Chapter 7 RS-232 Interface 119
- RS-232 Default Parameters 121
- RS-232 Host Parameters 122
- RS-232 Interface 7 - 5 123
- RS-232 Host Types 124
- RS-232 Host Types (continued) 125
- Baud Rate 125
- *Baud Rate 9600 126
- RS-232 Interface 7 - 9 127
- Parity (continued) 128
- Check Receive Errors 128
- *1 Stop Bit 129
- Hardware Handshaking 130
- RS-232 Interface 7 - 13 131
- Software Handshaking 132
- RS-232 Interface 7 - 15 133
- *Minimum: 2 sec 134
- *Host: Low RTS 135
- *Minimum: 0 msec 136
- RS-232 Interface 7 - 19 137
- ASCII / Character Set 138
- RS-232 Interface 7 - 21 139
- Table 7-4 140
- RS-232 Interface 7 - 23 141
- Chapter 8 USB Interface 143
- Connecting a USB Interface 144
- USB Interface 8 - 3 145
- USB Default Parameters 146
- USB Host Parameters 147
- USB Interface 8 - 7 149
- *No Delay (0 msec) 150
- USB Caps Lock Override 151
- USB Ignore Unknown Characters 151
- Emulate Keypad 152
- Function Key Mapping 153
- Simulated Caps Lock 153
- Convert Case 154
- Table 8-2 156
- USB Interface 8 - 15 157
- USB Interface 8 - 17 159
- Table 8-3 160
- USB Interface 8 - 19 161
- Table 8-5 162
- Table 8-4 162
- USB Interface 8 - 21 163
- Table 8-7 164
- Introduction 165
- IBM Default Parameters 167
- IBM 468X/469X Host Parameters 168
- Chapter 10 123Scan 169
- Chapter 11 Symbologies 171
- Symbology Default Parameters 172
- Symbologies 11 - 3 173
- Table 11-1 174
- *Enable UPC-A 175
- *Enable UPC-E 175
- *Disable UPC-E1 176
- *Enable EAN-13/JAN-13 176
- *Enable EAN-8/JAN-8 177
- *Disable Bookland EAN 177
- ISBN Format on page 11-19 178
- Symbologies 11 - 9 179
- Enable 491 Supplemental Mode 180
- Symbologies 11 - 11 181
- *Transmit UPC-A Check Digit 182
- *Transmit UPC-E Check Digit 183
- *Transmit UPC-E1 Check Digit 183
- *System Character 184
- Convert UPC-E to UPC-A 187
- Convert UPC-E1 to UPC-A 187
- *Disable EAN/JAN Zero Extend 188
- Bookland ISBN Format 189
- UCC Coupon Extended Code 190
- Code 128 191
- *Enable UCC/EAN-128 192
- *Enable Code 39 193
- *Disable Trioptic Code 39 193
- *Disable Code 32 Prefix 194
- Set Lengths for Code 39 195
- *Disable Code 39 Check Digit 196
- *Disable Code 39 Full ASCII 197
- *Disable Code 93 198
- Symbologies 11 - 29 199
- *Disable Code 11 200
- Set Lengths for Code 11 201
- Transmit Code 11 Check Digits 203
- Interleaved 2 of 5 (I 2 of 5) 204
- Symbologies 11 - 35 205
- *Disable 206
- Discrete 2 of 5 (D 2 of 5) 207
- Codabar (NW - 7) 209
- Set Lengths for Codabar 210
- *Disable CLSI Editing 211
- *Disable NOTIS Editing 211
- *Disable MSI 212
- Set Lengths for MSI 213
- *One MSI Check Digit 214
- *MOD 10/MOD 10 215
- GS1 DataBar 216
- *Disable GS1 DataBar Expanded 217
- Redundancy Level 218
- Redundancy Level 3 219
- Redundancy Level 4 219
- Security Level 220
- Bi-directional Redundancy 221
- Using ADF Bar Codes 224
- ADF Bar Code Menu Example 224
- Rule 2: The UPC Scanning Rule 225
- Alternate Rule Sets 225
- Special Commands 227
- Quit Entering Rules 228
- Disable Rule Set 229
- Criteria 230
- Code Types (continued) 231
- Code Lengths 234
- Code Lengths (continued) 235
- Any Message OK 239
- Numeric Keypad 240
- Numeric Keypad (continued) 241
- Rule Belongs To Set 242
- Send Data 243
- Send Data (continued) 244
- Setup Field(s) 246
- Move Cursor 247
- Send Pause 247
- Skip Ahead 248
- Skip Ahead (continued) 249
- Skip Back 250
- Send Preset Value 251
- Skip Back (continued) 251
- Modify Data 252
- Pad Data with Spaces 253
- Pad Spaces To Length 29 257
- Pad Spaces To Length 30 257
- Stop Pad Spaces 257
- Pad Data with Zeros 258
- Pad Zeros To Length 7 259
- Pad Zeros To Length 8 259
- Pad Zeros To Length 9 259
- Pad Zeros To Length 10 259
- Beep Once 263
- Beep Twice 263
- Beep Three Times 263
- Control Characters 264
- Keyboard Characters 269
- Send ALT Characters 283
- Send Alt \ 287
- Send Alt ] 287
- Send Keypad Characters 288
- Send Function Key 293
- Send Function Key (continued) 294
- Send Right Control Key 300
- Turn On/Off Rule Sets 306
- Turn Off Rule Set 1 307
- Turn Off Rule Set 2 307
- Turn Off Rule Set 3 307
- Turn Off Rule Set 4 307
- Alphanumeric Keyboard 308
- Table A-1 323
- Symbol Code Identifiers 331
- AIM Code Identifiers 332
- Programming Reference B - 3 333
- Table B-3 334
- Appendix C Sample Bar Codes 335
- 1 123 456 2 336
- 3 4567 89 012340 336
- 1234 567 0 336
- 12345ABCDE 337
- Æ1234567890Æ 337
- A1234567890A 337
- 123456789 338
- 12345678912345 338
- Appendix D Numeric Bar Codes 339
- 4, 5, 6, 7 340
- Numeric Bar Codes D - 3 341
- Alphanumeric Bar Codes E - 3 345
- Alphanumeric Bar Codes E - 5 347
- Alphanumeric Bar Codes E - 7 349
- Alphanumeric Bar Codes E - 9 351
- Alphanumeric Bar Codes E - 11 353
- Alphanumeric Bar Codes E - 13 355
- Alphanumeric Bar Codes E - 15 357
- Alphanumeric Bar Codes E - 17 359
- Glossary 361
- Glossary - 3 363
- Glossary - 5 365
- Glossary - 7 367
- Numerics 369
- Index - 3 371
- Index - 5 373
- Tell Us What You Think 375
Verwandte Produkte und Handbücher für Kommunikationszubehör Motorola LS3578
(92 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 2.018 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern