Motorola LS3578 Bedienungsanleitung PDF herunterladen (Seite 171)

Chapter 11 Symbologies

Introduction

This chapter describes symbology features and provides the programming bar codes for selecting these features

for the scanner. Before programming, follow the instructions in Chapter 1, Getting Started.

The scanner is shipped with the settings shown in the Symbology Default Table on page 11-2 (also see Appendix

A, Standard Default Parameters for all host device and miscellaneous scanner defaults). If the default values suit

requirements, programming is not necessary. Set feature values by scanning single bar codes or short bar code

sequences. To return all features to default values, scan the Default Parameters on page 5-4.

If not using a Synapse or USB cable, select the host type (see the specific host chapter) after the scanner emits

power-up beeps.

Scanning Sequence Examples

In most cases, scan only one bar code to set a parameter value. For example, to transmit bar code data without the

UPC-A check digit, scan the Do Not Transmit UPC-A Check Digit bar code under Transmit UPC-A/UPC-E/UPC-E1

Check Digit on page 11-12. The scanner issues a fast warble beep and the LED turns green, indicating a

successful parameter entry.

Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes in sequence. See the

parameter description for this procedure.

Errors While Scanning

Unless otherwise specified, if an error is made during a scanning sequence, re-scan the correct parameter.

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 377 378

Keine Kommentare

Motorola LS3578 Bedienungsanleitung Seite 171