Motorola LD-W-1 Spezifikationen PDF herunterladen (Seite 44)

English Locomotive decoders 30s series

Page 44

§ The lighting goes on and off when the speed levels are turned up

or the lighting cannot be switched on or off.

Possible cause: The speed mode of the decoder and the digital control

unit do not correspond. Example: The central is set to the mode 28

speed levels, but the decoder to the mode 14 speed levels. à Change

the speed mode at the central and / or at the decoder.

§ LD-G-30, LD-G-33 and LD-G-34 only: The decoder switches off in

operation, switches on after a short time and switches off again

immediately.

Possible cause: The overload protection was activated, as the

current consumption exceeds the decoder´s maximum total

current. à Check the current consumption of the motor and the

accessories. Possibly the decoder is not suitable for being mounted

in this locomotive.

If you cannot find the problem, please return the decoder for repair

(address on the cover page).

10. CE and warranty

Certification (CE)

This product is developed and tested in accordance with the European

standards EN 55014-1 and EN 61000-6-3. This product conforms with

the EC- directive 2004/108/EG on electromagnetic radiation and is

therefore CE certified.

To guarantee the electromagnetic tolerance in operation you must take

the following precautions:

§ Connect the transformer only to an approved mains socket installed

by an authorised electrician.

§ Make no changes to the original parts and accurately follow the

instructions, circuit diagram and PCB layut included with this

manual.

§ Use only original spare parts if you have to repair the decoder.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Keine Kommentare

Motorola LD-W-1 Spezifikationen Seite 44