Motorola LD-W-1 Spezifikationen PDF herunterladen (Seite 42)

English Locomotive decoders 30s series

Page 42

Optimising the CV-settings

Above all, the driving characteristics can be influenced by setting the CV#2

(starting voltage) and CV#5 (maximum voltage) and for the decoders for

d.c.motors (LD-G-versions), in addition, by setting the CV#124 (optimizing

the load control) and the CV#50 to #52 (parameters of the load control).

Make the setting for the load controlled decoders (LD-G-decoders) in the

following order, as far as required:

1. CV#124

2. CV#50 to #52

3. CV#2 and CV#5

To adjust the parameters for the load control (CV#50 to #52) the

following procedure is recommended:

If the locomotive is shaking: à Increase the value for CV#52 (KD) in 5-

steps. If this does not lead to an improvement of the driving

characterists, set the value of CV#52 back to factory setting (default

value). Then decrease the value for CV#50 (KP) in 5-steps and for

CV#51 (KI) in 2-steps.

If the locomotive does not have enough power and e.g. gets very slow

on the way uphill: à Increase the value for CV#51 (KI) in 2-steps,

until the locomotive starts to shake. Then increase the value for CV#52

(KD) in 5-steps. If this does not lead to an improvement or the

locomotive starts to shake immediately after increasing CV#51, set the

values for CV#51 and CV#52 back to factory setting (default value) and

increase the value for CV#50 (KP) in 5-steps.

If the locomotive is shaking heavily: à Decrease the value for CV#52

in 5-steps.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 51 52

Keine Kommentare

Motorola LD-W-1 Spezifikationen Seite 42