Motorola SG 2000 Betriebsanleitung PDF herunterladen (Seite 43)

Operation 5

-7

AT&T SLW2500 Installation and Operation Manual

CAUTION!

CAUTION!CAUTION!

CAUTION! Do not pull the optical connector out more than two inches from the casting wall. If you pull

the connector out too far, you must disassemble the module and respool the fiber.

7 To verify the position of the optical connector assembly, lift the metal tab and attempt to

remove the optical connector assembly from the module casting. The connector assembly

should slide out easily. If not, remove the sheet metal cover and verify the position of the

optical connector assembly. Release the metal tab and snap the optical connector assembly

back into place.

8 If necessary, re-install the SG2-LR in the node.

Return Path RF

The SG2-DFBT optical transmitter must be installed in the nodes optical transmitter B location.

The SLW25-RPLR must be installed in the A location. Figure 3-1 illustrates the correct location

for each module.

Figure 5-6

Typical return configuration

Return path

optical receiver

SLW25-RPLR

SG2-DFBT

optical

transmitter

JXP

BASE

LID

JXP

RPLP

filter

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 52 53

Keine Kommentare

Motorola SG 2000 Betriebsanleitung Seite 43