Motorola AP6532 Installationsanleitung PDF herunterladen (Seite 27)

AP6532 Series Access Point: Installation Guide

• Adopted to Controller - Select this option when deploying the access point as a controller

managed (Dependent mode) access point. Selecting this option closes the Initial AP Setup

Wizard. An adopted access point obtains its configuration from a profile stored on its

managing controller. Any manual configuration changes are overwritten by the controller

upon reboot.

Select the Automatic controller discovery option to enable the access point to be

discovered and adopted using layer 2 settings. If preferring layer 3 adoption, select the

Static Controller Configuration option, and define the addresses of the preferred

controllers. If using the static method, you’ll also need to define whether the access point

receives an IP address using DHCP or if IP resources are provided statically.

10. Select Next. The Initial AP Setup Wizard displays the Access Point Mode screen to define

the access point's routing or bridging mode functionality.

NOTE If designating the access point as a Standalone AP, Motorola Solutions

recommends the access point’s UI be used exclusively to define its device

configuration, and not the CLI. The CLI provides the ability to define more

than one profile and the UI does not. Consequently, the two interfaces

cannot be used collectively to manage profiles without an administrator

encountering problems.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 57 58

Keine Kommentare

Motorola AP6532 Installationsanleitung Seite 27