Motorola T3 Betriebsanweisung PDF herunterladen (Seite 17)

Motorola, Inc Page 17 of 24

1) Install the XLP-7038 switch in the central wiring closet

a) Install switch and other network devices in equipment rack

b) Interconnect the switch with the premises wiring

2) Install the CPE devices

a) Enable line power, check line status

b) Enable PoE power, check remote PoE device status

i) Note the XLP-701 supports 1 x 10/100Mb PoE devices

Type of Connectors Used

The XLP-7038 uses three types of connectors:

4) DB9 straight wired serial connector used for console connections on the Switch

5) RJ45 connectors are used for Ethernet devices

6) RJ11 connectors are used for premises wire connections

Bill of Materials

In addition to the Motorola XLP products, additional third party equipment is required.

Motorola Item Description

P/N

Qty Required

XLP-7038 Extended PoE Switch 553552-001-00 One for every 8 end points

XLP-701 PoE client 553521-001-00 One for each end point

Third Party Item Description Qty Required

Ethernet cables, 2m (for CO equipment and in-room) As needed

19" Equipment Rack As needed

Misc (AC power strip, wire management, etc) As needed

UPS or line conditioning power As needed

Aggregation Layer2 Ethernet Switch As needed

Note on Filters

The XLP system is not compatible with telephone signals on the same wire pair. Therefore, filters

are not necessary.

RJ-11 Premises Connector

Pins 2 and 3 are used for xDSL and Line Power

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Motorola T3 Betriebsanweisung Seite 17