Motorola T3 Betriebsanweisung PDF herunterladen (Seite 14)

Motorola, Inc Page 14 of 24

1) Install the XLP-6824 switch in the central wiring closet

a) Install switch and other network devices in equipment rack

b) Interconnect the switch with the premises wiring

2) Install the CPE devices

a) Enable line power, check line status

b) Enable PoE power, check remote PoE device status

i) Note the XLP-6802 supports 2 x 10/100Mb PoE devices

Type of Connectors Used

The XLP-6824 uses three types of connectors:

1) DB9 straight wired serial connector used for console connections on the Switch

2) RJ45 connectors are used for Ethernet devices

3) Keyed terminal connector are used for premises wire connections

Bill of Materials

In addition to the Motorola XLP products, additional third party equipment is required.

Motorola Item Description

P/N

Qty Required

XLP-6824 Extended PoE Switch 552681-001-00 One for every 4 end points

XLP-6802 PoE client 552679-001-00 One for each end point

Third Party Item Description Qty Required

Ethernet cables, 2m (for CO equipment and in-room) As needed

19" Equipment Rack As needed

Misc (AC power strip, wire management, etc) As needed

UPS or line conditioning power As needed

Aggregation Layer2 Ethernet Switch As needed

Note on Filters

The XLP system is not compatible with telephone signals on the same wire pair. Therefore, filters

are not necessary.

RJ-11 Premises Connector

Pins 2 and 3 are used for xDSL and Power

Keyed Terminal Connector

From left to right, the pins are numbered 1 through 8

Where used

This connector is used on the UTP premises wiring

between the XLP-6824 switch and the XLP-6802 client.

Note that the XLP-6800 system requires two or four wire

pairs for operation. To maximize performance and PoE

power at 3km, use all four wire pairs.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Keine Kommentare

Motorola T3 Betriebsanweisung Seite 14