Motorola T3 Betriebsanweisung PDF herunterladen (Seite 13)

Motorola, Inc Page 13 of 24

NOTE: Do not enable line power until filters have been installed on all telephones sharing

the wire pair. If line power is enabled without a filter, the phones will ring.

For a detailed list of commands, refer to the T2 or T3 Command Reference guide or T3 User

Guide. Details are available for configuring IP address, ACL, SNMP, VLANs, QoS, SNTP, IGMP,

etc.

General Commands for all WallPlates

Default IP address: 192.168.1.3

Default user name: admin

Default password: <blank>

1) Login using telnet or the serial console

2) Issue these commands (note: do not enable line power until after filters are installed on all

phones that share the wire pair)

a) interface dsl config port(1-25) max-down 75 max-up 10

b) interface dsl power enable port(1-25)

c) interface remote enable port(1-25)-(1-2)

3) Use these commands to monitor the system

a) show interface dsl status

b) show interface dsl statistics

c) show syslog messages level trace

4) Once filters are installed, line power can be enabled

a) Interface dsl po en portX

Review the diagnostics and monitoring section at the end of the document for explanation of the

line monitoring parameters.

Wireless Specific Commands

1) Create a WLAN Profile

a) wifi wlan profile add <SSID>

2) Assign the profile to a WLAN (16 supported per radio)

a) wifi wlan config wlanX-Y profile <SSID>

b) wifi wlan enable wlanX-Y

3) Enable a radio

a) interface wireless enable radioX

Where,

<SSID> is your selected SSID name

X is any dsl port, 1-25

Y is any of 16 WLANS per radio, 1-16

Note: Ranges can be used to specify additional DSL ports and/or WLANs

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Keine Kommentare

Motorola T3 Betriebsanweisung Seite 13