
5 - 16 WT41N0 User Guide
Connector Shroud
Assembly
1. Remove cable from wearable terminal, if required.
2. Align the cable connector with the connector shroud bottom housing. Ensure that the disconnect button on
the connector faces up.
Figure 5-16
Installing Bottom Housing
3. Place the cable connector into the shroud bottom housing as shown.
Figure 5-17
Installing Top Housing
4. Press the top housing into the bottom housing. The housings will snap together.
5. Plug the cable connector into the wearable terminal connector.
Disconnecting the Cable from the Wearable Terminal
1. Turn the wearable terminal over to expose the top housing of the shroud.
2. Push the tip of a ball-point pen through the hole in the connector shroud top housing. The connector
disengages from the wearable terminal.
NOTE Only use with RS409 or RS419 extended cable configurations.
Disconnect Button
Bottom Housing
NOTE Follow the instructions below when disconnecting the cable connector and shroud from the wearable terminal.
Once the shroud is installed on the connector, do not disassemble the shroud by prying it apart.
Kommentare zu diesen Handbüchern