Motorola Phaser P460 Spezifikationen PDF herunterladen (Seite 25)

2-5

Set Up

Charging the Battery

Before its first use, the scanner battery may need to be charged. It can be charged:

• Using the cradle

• Using a cable

• Using the UBC 2000.

Note:For a battery already in use, when the battery’s charge is almost

depleted, the scanner emits 4 high tone beeps, when the trigger is

pulled, indicating that it must be recharged.

Charging Using the Cradle

1. Connect the power supply to the power input jack on the cradle.

2. Connect the power supply to a receptacle supplying AC power of the proper

voltage level.

3. Insert the scanner into the cradle so that the nose of the scanner and tip of the

handle seat into the receptacles. The scanner displays “UNIT CRADLED” when

properly inserted in the cradle.

Figure 2-5. Placing the Scanner into the Cradle

4. Check the charge status indicator light. For additional information on charging, see

Table on page 2-6.

5. The battery charges automatically. A full charge of a depleted battery takes

approximately 3-1/2 hours.

Charge Status

Indicator Light

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 197 198

Keine Kommentare

Motorola Phaser P460 Spezifikationen Seite 25