Motorola minitor v Bedienungsanleitung

MINITOR V SELECTIVE CALL ALERT MONITOR RECEIVER USERS’ GUIDE

9 Several alert monitor field programmable options are available to include the following: • Priority Scan • Non Priority Scan • Silent Scan • Alert

10 OPERATION Perform the following steps to condition your alert monitor for operation: 1. Set the FUNCTION switch to a tone-alert position. 2. Rota

11 If the alert monitor detects a transmission on F2 it stops on F2 then listens for transmissions on F1. Scan back time is programmable and can be s

12 more, the alert monitor decodes tones on either F1 or F2 provided the alert monitor has listened to the appropriate channel at the correct time. H

13 Scan/Monitor Positions In these positions, the message is stored only when a properly encoded message is received. Other communications monitored

14 used to determine remaining battery capacity. To enable the battery gauge, press the reset button. This will illuminate the LED in the battery ga

15 Regulatory Agency Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This

16 Motorola, Minitor V, Minitor V logo, and VIBRA-Page are trademarks or registered trademarks of Motorola, Inc. Contents of this manual subject

1 Intrinsically Safe Radio Information Anyone intending to use a radio in a location where hazardous concentrations of flammable materials exist (haza

2 • Turn a radio off before removing or installing a battery or accessory. • Do not disassemble a UL Approved Product unit in any way that exposes the

3 INTRODUCTION Congratulations on your purchase of the Motorola MINITOR V Alert Monitor. Motorola’s advanced technology offers unique features and ben

4 BATTERY INSTALLATION NOTE: For optimum performance, the Ni-MH battery pack must be fully charged before operating your alert monitor. Install your

5 STANDARD FEATURES AND CONTROLS (All Models) ON/OFF Switch/Volume Control The ON/OFF SWITCH/VOLUME CONTROL is a combined single control located

6 message and alert tone is increased. Rotating the control in the opposite (counterclockwise) direction reduces the audio level, and turns the alert

7 (see Field Installed Options section for reset options). Some of these reset functions will place the pager in the monitor more. In these cases, o

8 by either incoming new messages replacing older messages or by turning the receiver off. Unread Message Indicator The red LED turns on if there are