Motorola Netopia Embedded Software Spezifikationen Seite 105

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 368
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 104
105
Configuring for Bridge Mode
1. Browse into the Motorola Netopia® Gateway’s web interface.
2. Click on the Configure button in the upper Menu bar.
3. Click on the LAN link.
The LAN page appears.
4. In the box titled LAN IP Interface (Ethernet
100BT):
Make note of the Ethernet IP Address and subnet mask.
You can use this address to access the router in the future.
5. Click on the Advanced link in the left-hand links
toolbar.
6. Under the heading of Services, click on the Ether-
net Bridge link.
The Ethernet Bridge page appears.
The appearance of this page varies, depending on your
Gateway’s interfaces.
7. If available:
a. Check the Enable Bridging on Port selection. (This
may be Always On.)
b. Click Submit.
8. If you want the Gateway to do both bridging
and routing, check the Enab
le Concurrent
Bridging/Routing checkbox.
When this mode is enabled, the Gateway will appear to
be a router, but also bridge traffic from the LAN if it has
a valid LAN-side address.
9. Check the Enable System Bridge checkbox.
The window shrinks.
Seitenansicht 104
1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 367 368

Kommentare zu diesen Handbüchern

Keine Kommentare