Motorola DSR-4530 Bedienerhandbuch PDF herunterladen (Seite 55)

DSR-4530 49

Operating the DSR-4530

Status2 Menu

Note: This menu is not displayed when the active signal is received from a source

other than an L-band input connector.

Press the

buttons until the Status2 menu appears (shown below). This screen

displays the source name, channel number, and the signal quality.

Source Field Default: Not in map

The Source field (two to eight alphanumeric characters) displays the name of the

transponder (source) to which the unit is tuned. The IRD displays Not in map when

the transponder name is not available and three dashes (---) when no information is

available.

Channel Field

The Channel field displays the selected virtual channel number (from the Channel

menu on page 34). The range is 0000 to 4095. Four dashes (----) are displayed

when no information is available.

Quality Field

The Quality field displays a number from 1 to 100 indicating the level of the signal

quality. If the signal is 50 or less, it is marginal. If it is 35 or less, take action to

increase the dish size or improve the reception by the LNB to prevent occasional

loss of output.

Note: The signal quality is also displayed as a large bar graph in the Status3

menu.

Status3 Menu

Note: This menu is not displayed when the active signal is received from a source

other than an L-band input connector.

Press the

buttons until the Status3 menu appears (shown below). This screen

displays the quality level of the active signal received from the L-band source and is

shown as a large bar graph that expands to fill the entire LCD screen.

E --- ---- ---

STATUS2 Source Channel Quality

Read-only

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 91 92

Keine Kommentare

Motorola DSR-4530 Bedienerhandbuch Seite 55