Motorola LS1000B Spezifikationen PDF herunterladen (Seite 39)

4-3

Programming the LS 1004

Introduction

This chapter provides information on how to program the LS 1004 scanner. Before

programming the scanner, follow the instructions in Set-Up on page 1-3.

The Table 4-1 illustrates the default values with which the scanner is shipped. If the default

values suit your requirements, scan the SET ALL DEFAULTS barcode. This will set the

scanner to the default parameters. Changing the scanner’s programmable parameters is

accomplished by scanning the bar codes provided in this section.

The following table lists the defaults for all parameters. If you wish to change any option,

scan the appropriate bar code(s).

Table 4-1. Default Table

Parameter Default Page Number

Set Default Parameter All Defaults 4-9

Host Interface Select RS-232C 4-9

Power On Beep Disable 4-11

Beep after Decode Enable 4-11

Beeper Tone Middle 4-12

Beeper Volume High Level 4-12

Decode Attempt Time 1 second 4-13

Operating Mode Low Power 4-14

Aggressive Scan Mode Disable 4-14

Transmit “No Decode” message No Message 4-15

Decode Redundancy Disable 4-15

Code Types All 4-16

UPC/EAN

Enable/Disable UPC/EAN Enable 4-17

Transmit UPC-A Check Digit Enable 4-17

Transmit UPC-E Check Digit Enable 4-17

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 95 96

Keine Kommentare

Motorola LS1000B Spezifikationen Seite 39