Motorola SURFboard SBV5322 Installationsanleitung PDF herunterladen (Seite 28)

20 M-eMTA Installation Guide

Connecting the AC Facility Power Source (Power Cable to Indoor

120 VAC Outlet)

Connecting the Power and Jumper Cables (Indoor Configuration Only)

Follow these steps when connecting the power and jumper cables:

1. Connect the ground wire. For more information, see “Connect the Grounding

Wire” on page 14.

2. Ensure that the telephone, data, and the RF-Connector cables are properly

attached. For more information, see “Grounding and Cabling the Chassis” on

page 13.

3. Follow these steps to remove the four bus-bars:

• Remove screws 1 and 3 on the AC1 and AC2 terminal blocks.

• Loosen (do not remove) the screws on the SP1 and SP2 surge

protectors.

• Remove the four bus bars.

• Retighten the SP1 and SP2 nuts after removing the bus-bars.

CAUTION: Use only one powering option at a time.

• To avoid personal injury, follow the NEC guidelines and/or local regula-

tions during the installation.

• Only use power cables that meet the NEC guidelines and/or local regu-

lations.

• When using the facility power, the SBV5506 should be connected to a

20 amp branch circuit that is part of the building installation. A licensed

electrician may be required to make this connection.

• The plug on the power cable acts as the power disconnect device for

the unit.

• Wire the power cable into the SBV5506 before connecting the plug to

the receptacle (socket outlet).

• The power supply cord must not be attached to the building surface or

run through walls, ceilings, floors, and similar openings in the building

structure. For indoor units, the power supply cord must not be installed

in a conduit.

• Installation measures must be taken to prevent physical damage to the

power supply cord including proper routing of the power supply cord

and provision of a receptacle (socket outlet) near the SBV5506 or posi-

tioning the SBV5506 near a receptacle (socket outlet).

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 46 47

Keine Kommentare

Motorola SURFboard SBV5322 Installationsanleitung Seite 28