Motorola PRO-900 Bedienungsanleitung

128-6847A1 of 16Kit Contents(1) Control Module(1) 3 Button High Frequency Transmitters(1) 5 Button Two Way LED Based Transceiver(1) On Glass Mount Sup

128-6847A10 of 1610Resistive Circuits, As Well As 4 Wire Polarity Reversal and 5 Wire Alternating 12 VoltDoor Lock Control CircuitsThese applications

128-6847A11 of 16113. Immediately turn the ignition key OFF.4. Hold the program switch ON, then start the vehicle using the ignition key.5. When th

128-6847A12 of 16If the unit fails this test, recheck your pin switch connection to the Gray/Black wire of the Audiovox Remote Start Unit.WARNING!!DO

128-6847A13 of 16from the ignition cylinder. This configuration prevents mechanical operation while the vehicle is in gear but offers noconsideration

128-6847A14 of 1614Circuits may be used only if the above circuit is not available.To connect to the key in sensor as shown in method 1:A. Locate the

128-6847A15 of 16NOTE: A second 4002 series diode may be required to maintain the integrity of the hood open, shut down circuit. Ifthis is the case,

128-6847A16 of 16© 2003 Audiovox Electronics Corp., Hauppauge, NY 11788 128-6847A

128-6847A2 of 16This Remote Start/Keyless Entry System is designed for use with Automatic Transmission Vehicles Only! The unitprovides wait to start

128-6847A3 of 163THE TRANSCEIVER/ANTENNA ASSEMBLY:The Superheterodyne Transceiver Antenna Assembly provided with this unit allows routing from below t

128-6847A4 of 16Failure to connect this wire to the ignition switch side of the neutral safety switch can result in personal injury andproperty damage

128-6847A5 of 16WIRING CONNECTIONS: 12 Pin Input / Output HarnessBlack Wire: Chassis Ground SourceConnect the Black wire to a known vehicle ground sou

128-6847A6 of 16Brake Switch Positive Shutdown DetailYELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass OutputNOTE: You must disconnect the ign

128-6847A7 of 167A. Shock Sensor By Pass:If there is Shock Sensor used with an alarm system and it is not shunted during the Remote Start activationpe

128-6847A8 of 16Green/Orange Wire: Tach Sensor InputThis wire will continually monitor the engine tach rate while the unit is under power of the Remot

128-6847A9 of 16NOTE: The outputs above are low current outputs and must be used with a relay if the circuit's requirement ismore than 300 mA.2