Motorola DSR315 Installationshandbuch

DUAL SATELLITEINSTALLATION MANUALSAC-00-094

SAC-00-094Step 7: While listening to the meter, apply gentlepressure to the top of the dish to move the dish – firstslightly downward, then upward to

11. TroubleshootingProblem #1: I’m having trouble finding the satellite signal.Try each of the following:• The cable can be plugged into any of the 4

Satellite Locator ChartCompass AzimuthDish ElevationNewfoundlandBonavista 264 14.4 126 267 12.1 127Cartwright 262 13.8 120 265 11.9 121Corner Brook 26

SAC-00-09413Montreal 239 28 119 243 26 121Mont Joli 247 22.9 119 251 20.9 121Natashquan 256 18.4 121 260 16.3 123Noranda 229 28.2 113 233 26.5 116Pare

14SAC-00-094Mekatina 218 31.4 110 223 29.9 113Michipicoten 216 30.8 109 221 29.4 112Midland 227 31.7 115 231 29.9 118Milne Inlet 259 7.1 98 263 6.6 99

15SAC-00-094Compass AzimuthDish ElevationDishSkewTown/CitySatellite ‘A’ Satellite ‘B’Compass AzimuthDish ElevationDishSkewCompass AzimuthDish Elevatio

16SAC-00-094Resolution Is. 259 12.2 110 263 10.9 112Somerset Is. 226 8 94 230 7.7 95Southampton Is. 230 14.9 101 234 14.2 102Spence Bay 212 11.4 95 2

Welcome to Shaw DirectThank you for choosing Shaw Direct. We’re confidentyou’ll enjoy all that Shaw Direct has to offer. Follow thesteps outlined in t

1. Getting StartedThis Shaw Direct Installation Manual provides all theinformation you require to install your system. Theinstructions are fairly simp

SAC-00-094Key points to remember when installing yourShaw Direct System:• Do not drill any holes until you’ve confirmed thebest location for the dish.

Before tightening the bolts, adjust the skew alignment to the90 degree mark on the Clamp Mount Assembly (see Figure C).Tighten the bolts just enough t

Step 5: Estimate the SAT B elevation (angle) setting you recorded earlier, using a protractor if needed (see FigureG). Check any obstructions at that

Step 6: Attach the Quad Satellite LNB/Feedhorn ClampAssembly to the Feed Support Arm. Loosen the Feed Armscrew enough to allow the clamp to fit snugly

SAC-00-094Position yellow cursor (using navigator keys on the remotecontrol) on the Provider ID and enter 4128 from the keypadTo access this menu for

If this LED light is RED it indicates NO SIGNAL is beingreceived by the satellite receiver. The dish is not properlyaligned to receive the Shaw Direct